Front Suspension OEM Rubber Replica Bushings for the Front of the Strut Rod - Set for both sides

This item is for a Replica Rubber set of four front strut rod bushings (FSRB), inner steel sleeves and cup washers to replace both side of your car.  SCP has created exact duplicates of the Ford E9SZ-3B271-A and F7SZ-3A225-AA bushings which are now obsolete from Ford.

The front strut rod bushings often go bad after 60,000 to 80,000 miles and result in a clunking sensation in your front end when going over bumps. The front suspension strut rod has bushings at each end (front at the subframe and rear where it goes through the lower control arms). This item is for a set of original type rubber front bushings at the front of the strut rod.

PLEASE NOTE there are FSRBs commonly available in the aftermarket using blue or black thermoplastic material from Moog, AC Delco, Mevotech, Quick Steer, SKP and likely EVERY PARTS STORE and I have one thing to say about them. DON'T BUY THEM! THEY ARE JUNK and will not perform as expected!  You will be lucky if they last 12 months of normal driving.  Our replica bushings will last 15+ years like your originals did!

If you are changing out your lower control arm along with the front strut rod bushings then I would DEFINITELY encourage you to change the rear SRBs as the strut rod goes directly through the lower control arm and these bushings support it at that point. Why put worn out bushings back in the car when these are a known high wear item?   SCP offers these also and are shown below in the "Related Products" area.