Driveline & Transmission

View as
Sort by
Display per page

LPW Ultra IRS Cover - Black Finish

LPW's Ultra IRS covers add much needed strength to vehicles with independent rear suspension!
$291.97

LPW Ultra IRS Cover - Silver Finish

LPW's Ultra IRS covers add much needed strength to vehicles with independent rear suspension!
$259.89

Steel Throttle Valve (TV) Grommet - Can SAVE Your AOD Trans.

Everyone should have one of these steel grommets/clips on your Throttle Body. These can save your transmission from burning up if the rubber grommet fails and the TV cable pops loose. If this happens your AOD transmission can become toast in a matter of minutes.
$13.87

BEEFY Poly Rear Differential Mount - A MUST HAVE ITEM !

Our "Beefy" polyurethane rear different mount is a HUGE improvement over the weak stock unit with its thin metal and flexible rubber. Wheel hop and general movement of the rear sub-frame starts with a weakly supported differential.

$349.86

Traction-Lok (Posi) Assembly for 8.8" Rear End - 28 Spline - IRS Specific!

Complete new Traction-Lok (TL) assembly! This TL unit is designed to specifically fit the Independent Rear Suspension (IRS) cars such as the '89-97 Tbirds/Cougars, the '93-98 Mark VIIIs, and the 28-spline IRS Cobras. The TL units from a solid axle car are NOT compatible with the IRS applications.

$435.87

UPGRADED DuraGrip Traction-Lok (Posi) Assembly for 8.8" Rear End - 28 Spline - IRS Specific!

Complete new upgraded Traction-Lok (TL) assembly with TWICE THE CLAMPING FORCE as our regular unit! This TL unit is designed to specifically fit the Independent Rear Suspension (IRS) cars such as the '89-97 Tbirds/Cougars, the '93-98 Mark VIIIs, and the 28-spline IRS Cobras. NOTE - The TL units from a solid axle car are NOT compatible with the IRS applications.

$491.83

4" Diameter 6061 T6 High Performance Lightweight Aluminum Driveshaft from Dynotech

A complete bolt-on 4.0" high performance drive shaft with new front yoke and rear flange already attached with new heavy duty U-joint. This shaft is fully assembled and ready to bolt in!

$721.87

3.5" Diameter 6061 T6 Lightweight Aluminum Driveshaft from Dynotech

A superior quality lightweight 3.5" diameter driveshaft from Dynotech Engineering. This is a complete bolt-on performance shaft with new front yoke and rear flange already attached with new heavy duty U-joint. This shaft is fully assembled and ready to bolt in!

$619.86