Engine

Featured products

Crank Position Sensor - '89-93 Thunderbird SC

SCP has reproduced the obsolete early model Super Coupe Crankshaft Position Sensors! IN STOCK for quick shipping!

$207.95

Coated Rotors with Upgraded Bearing Plate from Magnum Powers

Adding horsepower has never been as guaranteed as installing a set of abradable coated rotors to your M90 supercharger with the dramatically improved Magnum Powers bearing pack!

$895.99 $799.99

Power Steering EVO O-Ring Rebuild Kit with Line Seals

The supercharged Super Coupe and XR7 models came with Electronic Variable steering that can leak over time. This Kit replaces all the O-rings and seals that can be your source of leaks.

$30.95

EGR Block Off Plate

This block off plate fits all engines for all years for the '89-97 Thunderbirds/Cougars (except for '91-93 5.0L) and the '93-98 Mark VIIIs. Fits many other Ford applications as well. The bolt spacing on this plate is 1 11/16" for reference.

$21.98

Magnum Powers 10 Rib 15% SC & JS Pulleys, Belt & Tensioner Springs

This package includes a pair of 10 rib pulleys for the supercharger and the jackshaft that give a total of 15% overdrive for the supercharger. A premium quality 10 rib SC belt is included as well as a pair of the stiffer tensioner springs.

$446.21

Magnum Powers 10% Overdrive Crankshaft Pulley

This billet aluminum crank pulley is significantly lighter than the stock steel crank pulley and best of all...it allows for another 10% of overdrive on the supercharger without worrying about belt slippage. Typically adds 3 to 4 psi of boost.

$278.31

View as

Sort by

Display per page

Magnum Powers Supercharger "S" Porting and Rebuild

If your original '89-95 supercharger is in need of a rebuild and you are looking for budget minded performance upgrades also, this is the perfect solution for you.

$649.86

Magnum Powers Supercharger Rebuilding Service

Magnum Powers can re-build your early or late model Eaton blower and save you money!

$439.81

3-Jaw Supercharger Pulley Puller

What you need to remove your supercharger pulley.

$45.98

Lightweight Aluminum 10% Overdrive Supercharger Pulley

Pick up 3.5 psi of boost with this awesome looking SCP engraved aluminum blower pulley. Awesome gain in horsepower and torque and a huge improvement in throttle response!

$149.87

Short Supercharger Belt - Use with 10% SC Pulley

This is the proper high quality belt you will need in order to not have any slippage from your 10% SC pulley!

$58.96

Belt To Be Used With The Magnum Powers 10% Crank Pulley

This is the proper high quality belt you will need when running the Magnum Powers 10% overdrive crankshaft pulley.

$61.74

3.8L SC 3-Piece Accessory Underdrive Pulley Set - Show Polished Aluminum

An easy bolt on that yields 12 to 15 HP. This lightweight aluminum kit provides dramatically less parasitic drag from your accessories means more power can go to the rear wheels. These are no gimmick...they work like a charm!

$299.87

Set of 3 Steel Tensioner Pulleys - Save $5

These steel replacement idler pulleys will substitute for the original plastic ones that are likely worn out on your 3.8L SC motor if it has more than 100K miles. The original bearings can seize at any time leaving you stranded. They are also much quieter as they do not develop bumps on the outside diameter as the stock plastic pulleys do.

$83.73 $78.73